Offset / out of sync in Logic X

Doc · Post by **Doc** » Mon Feb 16, 2015 5:00 pm

Hi, short question here:

I'm routing Jamstix from one track to another that hosts EZD2 with the help of the IAC driver.
I'm getting sound (i.e. Jamstix plays EZD) but when I'm recording the midi out to the EZD track I realize it is not in sync with the metronome.

I remember having seen a workaroung for this but can't remember where.

Post by **Ralph @ Rayzoon** » Wed Feb 18, 2015 10:59 am

I think there was something stpete111 did in his video to sync things up with IAC:
https://www.youtube.com/watch?v=5gCcRzs9zPw

Doc · Post by **Doc** » Wed Feb 18, 2015 1:40 pm

Thank you, that was it.
Actually I had saved that clip for future reference but had forgotten the 'solution' is presented at the end.
DOH.

Still I get lots of system overloads in Logic, unfortunately.

Post by **Ralph @ Rayzoon** » Fri Feb 20, 2015 2:30 pm

Make sure the Jamstix track in Logic is NOT highlighted/selected when pressing play/record and JS should be a lot smoother.

Doc · Post by **Doc** » Fri Feb 20, 2015 6:43 pm

Thank you Ralph.
This works better.
I also need to insert 2 'start bars' at the beginning of the song before intro to switch briefly to the Jamstix track to sync to the metronome (like described at the end of the aforementioned video).
Oddities for sure, but it works.